Skip to main content

Edit an Automation Workflow and review versions

Learn how to change a published Prospect CRM workflow using drafts, and how to look back at earlier versions.

H
Written by Heather

Published Automation Workflows in Prospect CRM can't be changed directly, so live runs aren't affected while you work. Instead, you make changes in a draft and publish it when you're ready. You need to be a CRM Admin.


Edit a published workflow

Follow these steps to change a published workflow using a draft:

  1. Click Edit workflow.

  2. When you're asked, 'Would you like to create a new draft?', click Create Draft. If a draft already exists, you'll be offered Switch to Draft instead.The prompt asking whether to create a new draft of a published workflow

  3. Make and save your changes, and test them.

  4. When you're ready, publish the draft. It becomes the new live version.

To throw a draft away, click Discard draft. You'll return to the latest remaining version.

For more on testing and publishing, see Test an Automation Workflow and Publish and enable a workflow.


Review version history

Every publish creates a new version (v1, v2, v3 and so on). You can look back at earlier versions in two places.

  • See all published versions on the Versions tab.

  • In the builder, use the version selector (top right) to open any version. Each shows its number, publish comment, when and by whom it was published, and its status.

The Versions tab lists each version with its Status, when and by whom it was created, its number of Active Runs and its Publish Comment.

The Versions tab listing each version of a workflow

Version statuses

Status

Meaning

Published

The latest published version. It runs when the workflow is enabled.

Draft

Not yet published. Can be edited, tested and discarded.

Archived

An older published version that has been replaced by a newer one. Runs that started on it can still finish on it.


​

Did this answer your question?