An Automation Workflow in Prospect CRM only runs automatically once it's published and enabled. You can also disable a workflow to stop it starting new runs. You need to be a CRM Admin.
Publish and enable a workflow
Before you publish, check the workflow has at least one action step and that no steps show Needs setup. You can't publish a workflow without at least one action step, or while any steps show Needs setup.
Open the menu next to Edit workflow or Save workflow, then click Publish Workflow. While editing, click Save & Publish Workflow.

In the Publish Workflow window, select the Enable Workflow after publishing? checkbox to make it live straight away. It's selected by default. Clear the checkbox to publish the workflow without it running yet.

If the workflow has runs in progress, select the Upgrade Active Runs checkbox to move them onto the new version. Leave it cleared to let them finish on the version they started on.
Enter a comment in the Publish Comment field to describe what changed, for example 'Added second chaser'. This appears in version history.
Click Confirm.
The same menu has Test workflow and, for drafts, Discard draft. Once the workflow is published and enabled, the header shows Enabled and the menu offers Test workflow and Disable Workflow.

Disable a workflow
Disabling a workflow stops it starting new runs.
Open the menu next to Edit workflow.
Click Disable Workflow.
The header then shows Disabled.
📌Note: Runs that are already in progress aren't cancelled automatically. To stop them, cancel them from Run History. See View run history and manage runs.
Re-enable a workflow
You can turn a disabled workflow back on at any time.
Open the menu next to Edit workflow.
Click Enable Workflow.
